目次

目次

FlexScriptクラス - Animation

Animation

Description

A class that represents an object animation.

Methods

start Starts an animation.
stop Stops an animation.
update Updates an animation.

Details

Do no remove, this fixes the anchor on doc.flexsim.com

Animation.start()

void start( int speedType = 0 , double speedValue = 0 , int repeatType = 0 , double repeatValue = 0 )

Parameters

speedType

Used in conjuction with speedValue to manipulate the speed with which the animation is run. Can be one of the following values:

  • SPEED_TYPE_DEFAULT: The animation will run at the standard speed.
  • SPEED_TYPE_DURATION: The animation will run such that its total duration is equal to speedValue.
  • SPEED_TYPE_MULTIPLIER: The animation's run speed will be multiplied by speedValue. In other words, a speedValue of 2 will make the animation run at double-speed.
speedValue

See speedType.

repeatType

Used in conjunction with repeatValue to define how the animation will repeat. If not REPEAT_TYPE_DEFAULT, this will override the repeat type and value specified in the Animation Creator. Valid values are as follows:

  • REPEAT_TYPE_DEFAULT: The animation will use its default repeat information defined in the Animation Creator
  • REPEAT_TYPE_NONE: The animation will run just once.
  • REPEAT_TYPE_NR_ITERATIONS: The animation will repeat (repeatValue) times before finishing.
  • REPEAT_TYPE_USE_TIME: The animation will repeat indefinitely, but will start the animation over once it gets (repeatValue) time into the animation, which may be before the end of the animation.
  • REPEAT_TYPE_TIME_AFTER_END: The animation will repeat indefinitely, but will finish the animation and wait (repeatValue) time units before starting the animation again.
repeatValue See repeatType.

Description

Starts an animation.

current.animations["Walk"].start();
Do no remove, this fixes the anchor on doc.flexsim.com

Animation.stop()

void stop( )

Description

Stops an animation.

current.animations["Walk"].stop();
Do no remove, this fixes the anchor on doc.flexsim.com

Animation.update()

void update( double updateTime = -1 )

Parameters

updateTime

The simulation time on which to base the update. If not passed, it will update based on the current simulation time.

Description

Updates an animation.

The method will update all of the positions of an object's animation components based on the update time and the keyframes defined in the animation. Usually you do not need to call this explicitly, since FlexSim's engine automatically updates active animations when it repaints any 3D windows. However, if your simulation logic is dependent on sub-component positions that change during an animation, you should call update() before getting those positions, or else the retrieved data will be based on the last time a window was repainted. This will cause different results with each simulation run.

current.animations["Walk"].update();