The Entry Transfer panel defines the position and type of the entry transfer.
The following properties are on the Entry Transfer panel:
Position X, Y, Z
Changes the position of the entry transfer in the 3D model.
Defines how far along the decision point's conveyor the decision point is positioned.
Changing this value will update the Position.
Defines how items should be oriented when they enter the conveyor.
Max Transports In
Defines the maximum number of items that can be "in transit" to the entry transfer at a time.
In other words, it is the max number of task executer requests that can be simultaneously
made to transport items into the entry transfer.
Item Insertion Mode
Determines how items entering the conveyor through the entry transfer will be inserted
onto the conveyor. Options are:
Simple - Items must wait until the entry location
is clear. Items will be visually placed at the side of the conveyor until the space is
Block Upstream Items - If the entry location is
blocked when the item attempts to enter, upstream items will be stopped until the space
is clear and the item can enter on.
Clear Available Space - If the entry location is
blocked when the item attempts to enter, upstream items will be pushed backward until
the required space is available. The time to perform the push-back is based on the items
being pushed back at twice the conveyor speed. Note that the push-back time is only
important if transports are held when space is blocked. In this case, the transports are
held for the push-back time, and then they finish the unload. Note also that if this
option is chosen, there should be enough "clear" space on the conveyor to push items
back. Behavior is undefined if items must be pushed back off the conveyor, or if they
are pushed past conveyor transfers. If they are pushed back over decision points or
photo eyes, the triggers for those objects will NOT be fired again.
Hold Transports if Space is Blocked
If checked, task executers dropping the item off to the entry transfer must wait until
the entry point is available before finishing unloading the item onto the conveyor.