Photo Eye

Overview and Key Concepts

A photo eye is a versatile object you can use to build logic into your conveyor system. Photo eyes can also be linked to a merge controller to notify it when a released slug has cleared designated points in the system.

A photo eye can be in one of four states while it is interacting with items on a conveyor: blocked, cleared, blocking and clearing. Triggers fire when the photo eye goes into the blocked and cleared states. The following image illustrates the various photo eye states and triggers while interacting with items on a conveyor:

You can assign a photo eye custom behaviors or actions that it can perform when it enters either a blocked or cleared state. You can also define how long a photo eye must be in the "blocking" or "clearing" state before it moves to the "blocked" or "cleared" state. The colors for the "blocking", "blocked", and "clearing" states are defined on the properties of the Conveyor System.

Events

For information on events, see the Event Listening page.

The photo eye has the following events:

On Cover

On Cover fires when an item covers the photo eye.

It has the following parameters:

Event Parameter Type Explanation
Covering Item Object The item covering the photo eye
Conveyor Conveyor The conveyor the photo eye is on

On Block

On Block fires after an item covers the photo eye and the Block Time elapses before the photo eye is uncovered.

It has the following parameters:

Event Parameter Type Explanation
Blocking Item Object The item blocking the photo eye
Conveyor Conveyor The conveyor the photo eye is on

On Uncover

On Uncover fires when an item moves out of the photo eye leaving it uncovered.

It has the following parameters:

Event Parameter Type Explanation
Uncovering Item Object The item uncovering the photo eye
Conveyor Conveyor The conveyor the photo eye is on

On Clear

On Clear fires after an item moves out of the photo eye and the Clear Time elapses before the photo eye is covered again.

It has the following parameters:

Event Parameter Type Explanation
Clearing Item Object The item covering the photo eye
Conveyor Conveyor The conveyor the photo eye is on

States

The photo eye implements state using two different state profiles, namely the default state profile, and a custom "PhotoEye" state profile. The custom profile uses the following states:

Clear

The photo eye is completely clear.

Blocking

The photo eye was covered from a clear state, but its block time has not yet expired.

Blocked

The photo eye is covered and its block time has expired.

Clearing

The photo eye was uncovered from a blocked state, but its clear time has not yet expired.

The default state profile uses the following states. The current state can be viewed by clicking on the object and then viewing the Statistics pane in Properties.

Idle

The idle state corresponds to the clear plus blocking states in the photo eye's custom state profile.

Blocked

The blocked state corresponds to the blocked plus clearing states in the photo eye's custom state profile.

Statistics

The photo eye tracks the following statistics. These can be viewed by clicking on the object and then viewing the Statistics pane in Properties.

Content

The number of items that have covered the photo eye but have not yet cleared it. This is usually either 0 or 1, but if the photo eye has an offset angle, it may be greater than 1.

Input

The total number of items that have covered the photo eye.

Output

The total number of items that have cleared the photo eye.

Properties Panels

The Photo Eye uses the following properties panels:

Properties

The Photo Eye object uses the following properties:

  • BlockTime
  • CenterObjects
  • ClearTime
  • DensityThreshold
  • DistAlongConveyor
  • InObjects
  • ItemEdge
  • MassFlowMode
  • OffsetAngle
  • OutObjects
  • PhotoEyeHeight
  • RequireGapToClear
  • SpeedThreshold