You use a table to enter these different values. In this table, max speed attributes are broken out by both path class and load type, whereas acceleration, deceleration, and battery depletion attributes are broken out by load type.
When you define multiple AGV Types, you need to specify which AGVs are associated with which AGV Type. You do this by clicking on the AGV in the 3D view, and then specifying the AGV Type in the AGV Properties pane.
The AGV Types tab has the following properties:
You can get to the AGV Types page by right-clicking on a Path or Control Point and choosing AGV Network Properties.
Here you can add, remove, reorder and rename the set of Path Classes for the model. Path Classes are specifically used for breaking out AGV max speeds by path. When you add a Path Class, a new speed row associated with that Path Class will be added to each AGV Type table for both forward and reverse speed.
Here you can add, remove, re-order and rename the set of Load Types for the model. Load Types are a user-defined list defining categories for what an AGV is carrying. This allows you to break out AGV speeds by the AGV's current load. The load type is resolved at the beginning of each travel operation, via the Initialize Travel field.
This is a trigger that is fired at the beginning of each travel operation. The primary objective of this trigger is to set the AGV's current Load Type.
Here you can add, remove, re-order and rename the list of AGV Types for the model.
In the AGV Type Spec Table you define max speeds by Path Class, Load Type and AGV direction, as well as acceleration, deceleration and non-idle battery usage.
Each AGV Type has a defined Battery Capacity (in Amp Hours), Idle Battery Usage (in Amps), and Recharge Rate (in Amps). Additionally, each AGV Type has a non-idle Battery Usage (in Amps) broken out by Load Type. Each AGV starts the simulation at its maximum battery capacity, and then will track its battery usage over the course of the simulation. Whenever it is idle, its Idle Battery Usage applies. Whenever it is doing a travel operation, its battery usage is based on its current Load Type. If you set the AGV to recharge, it will recharge at its recharge rate until it is full or it starts its next travel operation, whichever comes first. To query battery level, start a recharge, or manually set the battery level, etc., see the documentation for the agvinfo() command.
You can also make the AGV attach loaded items as trailers to the AGV. This will make the loaded items trail behind the AGV on its path, instead of being carried on the AGV. Check the box Attach Loads as Trailer, and then define the Trailer Gap, which is the distance of the gap between the back of the AGV and the front of the trailing item.